The guys at Nene Marine did a sterling job, cutting out the damaged gas locker, and then welding a shallower locker in, incorporating a gas drain that is not right on the waterline!
 |
| The bottle still fits fine but does not sit so low, this makes it easier to get in and out and gives more room under the locker so that I could clean, de-rust and paint the top of the counterplate and that is where our newly painted, large chunks of cast iron ballast now reside. I have now painted inside the locker and moved the bubble-tester to the side, unfortunately the regulator valve was leaking so we have used Christina's until our new valve with built in gauge arrives. |
I also had to remove the redundant cat-flap and re-instate the air vents and swap two of the fire-extinguishers over to comply with the up and coming BSS.
It was nice to meet Ian Jennings who did our safety examination and Freyja passed with flying colours ;o)
No comments:
Post a Comment